Parkside PMML 5 A1 Operation And Safety Notes page 24

- Measurements start from the meas-
urement starting edge
the bottom side of the product is the
distance measuring reference point
.
25
- Should the measurement lie outside
the measurement range, "Err" or an
illogical number appears on the dis-
play
lies between 0.175 m and 20 m.
- Make sure that there is no "Err"
message shown on the display before
any measurement. "Err" message
can always be cleared by pressing
the MODE key
message still exists, press the MODE
key
4
message is cleared from the display
.
2
- Hold the product upright towards
the wall to which you wish to meas-
ure the distance. The laser receiver
must be at a right-angle to the wall.
For this, make use of spirit level. The
bubble in the vial
tween the marked lines.
24 GB/IE/NI
. The measurement range
2
4
repeatedly until the "Err"
. It means,
1a
briefly. If "Err"
must stand be-
8
16