Delta DX-3001 Series User Manual page 53

D X-3 001 Se ri es Ind ustr ia l C lou d Ro u ter
_3
Serial Server –
TCP Client
3 - 2 8
Description
AS series PLCs
Other: Use this option for non-Delta PLCs.

Address Type
Depending on the selected controller type change:
Delta PLC: The address type is "D"

Other: The address type is "W"

Slave Starting Address (decimal)
Set up the slave starting address for read/write the
registers in a PLC.
Delta PLC: Enter the internal D register number. If

you need to read / write D0, please enter 0 here.
Other: Enter the hexadecimal actual address. For

example: Holding Register: 400100, take 0100
(decimal) that is 64 (hex).
Supports the Holding Register : 400001~465535
(Decimal)
Device Starting Address (decimal)
Set up the device starting address (decimal, input range
is from $2048 to $4095). $ specifies that the match must
start at the beginning of a Device Starting Address.
Length (1-123)
Here displays the number of the continuous address
followed by the default mapped address.
Add Mappings
Click the button to add mappings; the data mapping
can be set to 200.
Edit
Click an item of register mapping forms that can be
edited.
Operation
The added mappings can be deleted here.
TCP Alive Check Time
Set up the keep alive time of TCP connection. Range
from 0 to 99 minutes.
0: Never disconnect the connection
1 ~ 99: Disconnect the TCP connection after the idle
time meet the set value
Destination IP address and port
Set the IP address and port of the serial server. Up to 4
Default
D
N/A
N/A
N/A
N/A
N/A
N/A
7
192.168.1.100