Table of Contents
Advertisement
D X-3 001 Se ri es Ind ustr ia l C lou d Ro u ter
Last IP Address
To increase the number of addresses available to clients, you can change
the End Address.
STP
STP is a network protocol that builds a logical loop-free topology for Ethernet
networks. The basic function of STP is to prevent bridge loops and the
broadcast radiation that results from them. If this STP is enabled, the traffic
usage will increase about 15Mbit in 24 hours.
_3
3.3
Firewall
3.3.1
MAC Filter
This page is used for setting up the MAC Filter, including configuring the MAC Address, Device Name and Status.
MAC Filter is used to block particular MAC address from the local network. Select Enable/Disable to activate/deactivate
this functionality. Click the "Add A MAC Address" to block the MAC Address.
After clicking the "Add A MAC Address", you will see the following page.
MAC Address
Manually input the MAC address that you'd like to block.
Device Name
Set up the device name corresponding to the set MAC address.
Status
3 - 1 6
Description
Description
Default
192.168.1.200
Disable
Default
N/A
N/A
Advertisement
Table of Contents
