Plow Control; Standard Control - SaMASZ City 150 Operating Manual

lower plow's hitch onto vehicle's/tractor's front linkage (with use of the hydraulics),
upon mounting of the hitch on DIN linkage, protect the connection with M24 bolts.
Place hitch holders in
front linkage connectors
If a vehicle has no floating option for lifting cylinder available, then:
lift the plow up by means of vehicle's hydraulics and turn off connector's valve located near
EURO plug. This allows for smooth ground following.

5.3. Plow control

5.3.1. Standard control

ATTENTION:
Prior to mounting plow make sure that polarity of aggregated machine is the
same as driver's (Fig. 11). Wrong polarity will cause damage to the driver.
Once hydraulics and power plug are connected, move control panel along with cable to tractor's
cabin and connect the plug to lighter's connector 12V (Fig. 12). In order to lift/lower the plow, use
control lever for tractor's front 3-point linkage. Hydraulics control lever is used to rotate shield.
Switching between right and left plow's shield is possible thanks to switch (B2) on control panel (B).
Operating manual
Fig. 10. The City Up plow mounted on the truck
Fig. 11. Polarity of driver's plug
Tractor mounted snow plow
City, City K, City Up
Protect hitch with bolts
by screwing to front
linkage
̶
- 11 -
+