Graco HVLP Series Operation, Parts page 29

Cleaning HVLP Edge II Gun
NOTICE
Solvents, such as lacquer thinner, can
damage parts of the HVLP Edge II gun. Do
NOT immerse parts of the HVLP Edge II
gun in solvent.
1. Remove retaining ring and air cap.
2. Trigger the gun and remove fluid nozzle
from gun.
NOTE: Edge II Plus guns contain air cap
guide and spring held in place by fluid nozzle.
Upon removal of fluid nozzle, set aside air
cap guide and spring.
NOTICE
Trigger the gun whenever removing or
installing the fluid nozzle. This prevents the
fluid nozzle and needle seating surfaces
from being damaged.
3A5085C
3. Move trigger slide from SPRAY position
(A) to NEEDLE REMOVAL position (B).
SPRAY
Position
A
4. Remove needle from front of gun.
Do not use a pliers to remove needle.
Damage to the needle tip will cause leaking
at the fluid nozzle.
ti30850a
Cleanup
NEEDLE
REMOVAL
Position
B
NOTICE
ti30851a
ti30852a
29