Table of Contents
Advertisement
If using FlexLiner System:
4.
Point gun into a waste area. Evacuate air
from FlexLiner System by holding gun
vertically and pull trigger open until a
continuous spray pattern is observed.
NOTE: Tilt gun back and forth to help in
evacuation of air.
ti30687a
3A5085C
If using remote cup with ProComp Model:
5.
Turn pressure regulator to lowest
setting.
6.
Turn compressor ON/OFF switch to ON
position.
ti30892a
NOTE: If experiencing low remote cup
pressure, disconnect clear air hose from
compressor outlet (see step 2, page 15) and
allow compressor to run for 10 seconds.
Reconnect air hose.
Startup
ti30904a
21
Hide quick links:
Advertisement
Table of Contents
