Oracle F320 User Manual page 33

Refer to the servers service manual for PCIe slot locations in the server.
Refer to "Supported Hardware and Software" in Oracle Flash Accelerator F320 PCIe Card and
Oracle 3.2 TB NVMe SSD Product
4. Prepare the server for service.
Hazardous voltages are present. Disconnect the server from the main power and from
Caution -
any networks before installing the card to avoid electrical shock.
Your server chassis might require a PCIe carrier extension for each installed Oracle Flash
Note -
Accelerator F320 PCIe Card to facilitate air flow. Your server chassis might contain a card
carrier or other configuration. Refer to the servers service manual for PCIe card installation
instructions.
Ensure that you have already taken antistatic measures.
a.
See "ESD Safety Measures" on page
b. Remove the server from active operation.
Turn off the server.
c.
Power down the system.
d. Disconnect all power cords from the server power supplies.
Remove the cover from the chassis.
e.
Record the serial number of the Oracle F320 Flash Card and PCIe slot number
5.
where the card will be installed.
This server slot information can be used at a later time for identifying Oracle F320 Flash Cards
from the console.
Refer to the servers service manual.
6. Insert the Oracle F320 Flash Card in the supported PCIe slot.
Remove the blank bracket panel on the server chassis that aligns with the
a.
empty PCIe slot. Save the bracket screw, if applicable.
Press down gently, but firmly, to properly seat the card in the slot.
b.
Install a New Oracle F320 Flash Card (Server Power-Off)
Notes.
26.
Installing the Oracle F320 Flash Card 33