Edge ® Remote Instructions - Garmin Edge Instructions Manual

Edge Remote Instructions
®
Device Overview
Lap key. Select to mark a new lap.
Action key. Select to start and stop the timer. Hold to turn on the
backlight.
NOTE: This is the default functionality of the action key. The action
key functions are programmable.
Page key. Select to scroll forward through the data pages. Hold to
scroll through the data pages in reverse.
Status LED.
Status LED
LED Activity Status
Flashing green Searching for a paired device.
Alternating red and green Attempting to pair with a new device.
12 rapid green flashes Successfully paired with a device.
Four rapid green flashes Successfully sent a command to a device.
Four rapid red flashes Failed to send a command to a device.
Pairing the Remote with Your Edge Device
The first time you connect the Edge remote to your Edge
device, you must pair the remote with your device.
1
Bring the remote within 3 m (10 ft.) of the device.
NOTE: Stay 10 m (33 ft.) away from other ANT+™ sensors
while pairing.
2
From the Edge home screen, select
Sensor > Edge Remote.
3
On the remote, hold two keys simultaneously until the status
LED starts alternating green and red, and release the keys.
The remote searches for your device. When the remote pairs
successfully, the status LED flashes green 12 times, and the
remote name appears on the device.
4
Select the remote, and select Add.
After the remote is paired, it connects to your device whenever
the device is in range and turned on.
Customizing the Action Key
1
From the Edge home screen, select
Remote > Sensor Details.
2 Select Single Press or Press and Hold.
3
Select a function for the action key.
For example, you can set the action key to display the map
or turn on the backlight.
Using the Mounts
Several mounts are available for your remote, either included
with the product or as an optional accessory. The mounts allow
you to attach the remote to your body, your bike, or other
objects.
2
• Align two of the notches
• Press gently on the release tab
Replacing the Battery
Do not use a sharp object to remove batteries.
Keep the battery away from children.
Never put batteries in mouth. If swallowed, contact your
physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate
material. Special handling may apply. See
www.dtsc.ca.gov.hazardouswaste/perchlorate.
Contact your local waste disposal department to properly
recycle the batteries.
Before you can replace the battery, you must have a small
Phillips screwdriver, a small flat screwdriver, and a CR2032
lithium coin-cell battery.
1
> Sensors > Add
2
3
4
> Sensors > Edge
5
press the remote into the mount until it clicks.
the mount.
WARNING
CAUTION
Using a Phillips screwdriver, remove the three screws from
the back plate .
Remove the back plate from the remote.
Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and
contacts from damage.
Carefully pry the battery from the back plate.
Install the new battery into the back plate with the positive
side facing down.
with the sides of the mount, and
, and lift the remote from