Table of Contents
Advertisement
Available languages
Available languages
User manual / Bedienungsanleitung
2.5 Installation on other turntables
VTA-Lifter
To install the
on the turntable chassis, you will need to drill the required holes.
Please refer to the drilling template shown below (Picture 8) for the measurements to mark the exact drilling
holes.
Please be informed, that this drawing is not suitable for use as a mounting tool.
Use a 3.2mm HSS drill bit.
Please note:
This drilling template is only for 9 inch tonearms. You will find the the correct pivot to spindle
in the user manual of the tonearm.
Pic. 8: Mounting the
VTA-Lifter
on a non-Clearaudio turntable
Made in Germany
7
Advertisement
Chapters
Table of Contents
