Connecting To The Control Input Terminal; Connecting The External Equipment Between The Line Output And The Power Amplifier - Toa A-3606D Operating Instructions Manual

8.7. Connecting to the Control Input Terminal

Priority broadcast can be controlled by inputting the contact signal to these terminals.
For the priority setting, refer to the separate setup manual, which can be downloaded from the TOA DATA
Library (https://www.toa-products.com/international/).
For cable wiring to the removable terminal plug, refer to p. 18.
Input 2
Input 4
Input signal specifications: Short-circuit current: 10 mA or less, open voltage: 35 V DC or less

8.8. Connecting the External Equipment between the Line Output and the Power Amplifier

Appropriate sound can be obtained by connecting a signal processor like an equalizer or limiter between the
unit's preamplifier section (Line output jack) and the power amplifier section (Power amplifier input jack).
Notes
• When using the signal processor, be sure to turn OFF the unit's line output interlock switch.
• Inserting a pin plug into the unit's power amplifier input jack disconnects the preamplifier section from the
power amplifier section inside the unit.
Tip
Either Line output 1 or 2 can be used.
A-3606D/3612D/3624D/3648D
Line output specifications:
Power amplifier input specifications: 0 dB*, 600 Ω, unbalanced, RCA pin jack
Input 1
Input 3
0 dB*, 600 Ω, unbalanced, RCA pin jack
A-3606D/3612D/3624D/3648D
IN
Signal processor
OUT
* 0 dB = 1 V
17