Vestax HDR-V8 Operational Manual page 29

5. AUX SEND FUNCTION
This function is used to set the AUX sends to pre fader or post fader.
The AUX sends of each track can be selected either to take the signal
from before the fader (pre fader) or from after the fader (post fader).
The AUX sends (AUX 1 to 3) can only be set to all pre fader or all post
fader per track.
1. Press SETTING button and select "AuSEnd" by turning dial.
2. Press ENTER button.
3. Select the track by fuming Jog Dial.
4. Press ENTER button.
5. Select "Post" or "PrEFAd" by using Jog Dial.
6. Press ENTER button.
6. 2nd HARD DRIVE
This menu allows you to utilize an additional IDE-hard drive for your HDR in one
of two ways. Option 1 is to use a second internal hard drive either
in conjunction with the first (to extend recording time), or to back up and
load from, in lieu of DAT tape. Option 2 is to backup and load to external
device (SyQUest /SyJet cartidge-based systems).
1. Press ENTER
2. Choices are Record - extends recording time automatically.
*if you change this, anything that is recorded on 2nd HD may disappear.
Do not change unless sure.
7. AUTO IN FUNCTION
This function is used to select the monitoring mode while recording or
punching in / out.
Auto In mode
In this mode, the playback signal can be monitored on Play or Stop and
input source can be monitored on Recording or between Punch In and Punch
out.
No Auto mode
In this mode, the input source can be monitored all the time once
the track is armed to record. Procedure to change to the No Auto
mode.
1. Press MENU button and select "Auto In".
2. Select "no Auto" by turning Jog Dial.
3. Press ENTER button to change to No Auto mode.
Bac Up - used to back-up to