Setting The Open Condition - Keysight Technologies 16194A Operation And Service Manual

Operation

Setting the Open Condition

Setting the Open Condition
1. If there is any device on the electrodes, remove it.
2. When measuring a surface mount device, move the arm outward and latch
3. When measuring a leaded device, make the distance between the
Figure 3-3 Setting Open Condition
Keysight 16194A High Temperature Component Fixture
it. Then make the distance between the electrodes same as the device size
by adjusting the ground plate
electrodes and the distance between the device holder's pins same as the
device size. Then press the electrodes with the device holder's pins, not
latching the arm (Figure 3-3
(Figure 3-3 (a)).
(b)).
19