Exchanging The Device Holder - Keysight Technologies 16194A Operation And Service Manual

Preparation for Use

Exchanging the Device Holder

Exchanging the Device Holder
The 16194A can hold both leaded devices and surface mount devices by
exchanging the device holder. The exchanging procedure is as follows.
1. Remove the ground plate.
2. When measuring a surface mount device, attach the knob on the device
3. Select the device holder suitable for the device type. Loosen its knob and
4. Set the ground plate.
Figure 2-2 Exchanging the Device Holder
Keysight 16194A High Temperature Component Fixture
holder as shown in Figure
insert it into the arm.
2-2.
13