Table of Contents
Advertisement
Operation
Placing Shorting Device, Load Device, or Device Under Test
Placing Shorting Device, Load Device, or Device Under Test
1. Adjust the position of the ground plate and tighten its knob.
2. Adjust the position of the device holder so that it presses against the device.
3. Move the arm outward.
4. Place the device on the electrodes and press it with the device holder
You can adjust the pressure of the arm by turning the pressure adjustment
using the wrench.
Figure 3-2
Placing the Device
18
When measuring a leaded device, adjust the distance between the two pins
to the device size. Then tighten the knob of the device holder.
(Figure 3-2
(b) - (d)). When placing a leaded device, put its leads on the
notch of the 16194A's electrodes.
Keysight 16194A High Temperature Component Fixture
Advertisement
Table of Contents
