Example - Programming Work In Program Pr.3 - DK System DK LOGIC 100 Manual

7.2 Programme Pr.3 - user settings (cont.)
6. Once the settings are done, press
until the main scree is shown.
7.3 Example - programming the automatic operation mode
A thermostat will be programmed for the entire
week between 6 - 9 and 16 - 21 and a daily tempe-
rature of 22°C will be set; for the remaining period
of the day, a lowered temperature of 17°C, as per
the diagram below, will be set.
1. Set the values of a day and night temperature
as described in point 15 "Setting the default
day and night temperature".
2. Press twice till the PROG symbolsis shown
on a screen and confirm by pressing
3. Use the "-/+" buttons to select the Pr. 3 and
confirm by pressing
displayed.
4. Use the "-/+" buttons to select the dP.n range
(from Monday to Sunday) and confirm by
pressing
t
then an hour for which the start of the first day or
night temperature range in this period must be
displayed
Room thermostat DK LOGIC 100
. A d.1 symbol will be
t
. Pn.U1 will be displayed, and
twice
AUTO
°C
22
17
PROG
.
t
PROG
PROG
PROG
PROG
6 9 16 21 hours
9