Momentary Temp. Change In Automatic Mode - DK System DK LOGIC 100 Manual

Table of Contents

Advertisement

7.3 Example - programming the automatic operation mode (cont.)
8. Use the "-/+" buttons to set the hour to 21:00;
and the button
confirm by pressing
range Pn:U5 will appear on the screen, and
next the hour at which it should start.
9. Confirm by pressing
changes). A symbol of the next range Pn:U6
will appear on the screen, and next the hour at
which it should start.
10. Without making any changes, press
few times until the main screen is shown.
Note: If no changes are made for three minutes in the PROG mode,
!
the controller will automatically go to the AUTO mode.

8. Momentary temp. change in automatic mode

This function allows temporary change of the heating temperature set in AUTO
mode. It can be made by pressing the "-/+" buttons; such a temperature will be
maintained until the activation of the next program.
Room thermostat DK LOGIC 100
to set the symbol
. A symbol of the next
t
(w/o introducing any
t
and
PROG
PROG
PROG
PROG
PROG
for a
AUTO
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DK LOGIC 100 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents