Par4 Mode - Hysteresis; Setting A Default Day And Night Temperature - DK System DK LOGIC 100 Manual

16. Tryb PAr4 - hysteresis
Par4 Hysteresis.This parameter specifies the number of degrees C by which
the temperature in the room below the preset temperature must fall in
order for the thermostat to switch on the relay.
to 2 ° C. Factory setting 0.5 ° C.
Input settings:
1. Press the
symbol appears. Confirm by pressing
2. Use the "- / +" buttons to set the hysteresis
value. Confirm with the button
moment the regulator will automatically go to
the main screen view.

17. Setting a default day and night temperature

1. Press the button
comfortable temperature (day) will appear on
the screen - the factory pre-set temperature is
21°C. Use the "-/+" buttons to set the parame-
ters as per the user's request; use the
confirm and to switch to the main screen; press
to go to the default settings of the lowered
(night) temperature
2. Current default lowered (night) temperature will
be displayed on a screen - the factory pre-set
temperature is 18°C. Use the "-/+"buttons to set
the parameters as per the user's request and
use to confirm; the controller will show the
t
main screen taking into account the introduced
settings.
Room thermostat DK LOGIC 100
button for a few times till the PAr4
; currently set default
Setting range from 0.1 ° C
.
t
- after a
to
t
AUTO
15