Additional Functions - Vetter SmartFork Operating Instructions Manual

4.3.3

Additional functions

Various functions are available while the control system is connected to the software:
Fig. 8: Function selection screen
The following functions are possible:
Name
1. Change Mode
2. Download/
Upload/Save
3. Export Parameter This function can be used to export the selected settings for the
4. Import Parameter This function loads the exported configuration into the software.
5. Restore
6. Restart
V.09/2019
Function
The control system is put into "Config Mode" when the connec-
tion is established between the software and the control system.
This causes the LEDs to go out. "Change Mode" can be used to
switch between "Operational Mode" and "Config Mode". This
allows positions to be checked following the "Upload", for
example. However, it is necessary to note that an "Upload" or
"Download" is only possible in "Config Mode".
These functions correspond to the "Upload", "Download" and
"Save" buttons in the "Signals" tab.
control system. These are stored in a corresponding configura-
tion file (*.bin).
The "Restore" function can be used to restore and store the
default settings that are stored on the control system.
This function carries out a soft reset of the control system.
®
SmartFork Flash control device
Configuration by means of PC > Additional functions
Settings
17