Selector Switch S2; Selector Switch S3; Button S4; Potentiometer - Vetter SmartFork Operating Instructions Manual

4.1.2

Selector switch S2

Selector switch S2 (Fig. 3) determines the function of channel 2. Activation by moving the
respective switching contact to the ON position. It is not possible to change between dif-
ferent functions.
Contact
1
2
3
4
4.1.3

Selector switch S3

Selector switch S3 (Fig. 3) specifies which source is used to display the insertion depth.
Switch S3 switching position
Switch position "OFF", internal potentiom-
eter on
Switch position "OFF", internal potentiom-
eter at "0"
Switch position "ON"
4.1.4

Button S4

Button S4 (Fig. 3) is responsible for 2 functions:
n Determines the change between the states Hardware Config Mode and Operational
Mode of the device.
n In "Hardware Config Mode" state, the device setting is made via button S4.
4.1.5

Potentiometer

When activated, the potentiometer (Fig. 3) generates a direct analogue value that oper-
ates the insertion depth display (see table, Selector switch S3).
V.09/2019
®
SmartFork Flash control device
Settings via switches and buttons > Potentiometer
Function
Parking light
Chasing light
Insertion depth
Depth mark
Source for displaying the insertion
depth
Value for the internal potentiometer is
used.
Value stored in the software is used.
An external analogue signal is processed/
expected (0-10V)
Settings
11