Basic Setup; Pre-Programmed Method - Universal Remote Control Customizer URC-300 Owner's Manual

Basic Setup

You can start setting up your Customizer using either the
Pre-Programmed Method or the Learning Method.
However, all the buttons of the Customizer are setup at
once with the Pre-Programmed Method, so it is usually
faster than the one-button-at-a-time Learning Method.

Pre-Programmed Method

Power on the A/V component you wish to setup, so that
1
you can test codes by sending power off commands.
Refer to the pre-programmed code tables on pages
2
33 - 47 and write down the code numbers listed
for your A/V component. The code numbers are
listed by categories of devices, then by brand. See
page 33 for a category list.
Press and hold the MAIN and ENT (Enter) buttons
3
at the same time for approximately three seconds.
The top of the display will show "SETUP". You are
in SETUP mode now.
Note: You have 30 seconds to perform a step while you are
in SETUP mode. If you don't press a button within that time,
the Customizer will time out and return to normal operation.
MAIN
Button
U R C - 3 0 0
5
ENT
Button