Replacing Batteries Before you program or operate the remote control, you must install two new AA alkaline batteries. STEP1 Removethebatterycompartment cover fromthebackofyourremotecontrol. STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. STEP3 Replace the battery compartment cover.
Page 4
STEP2 Point the remote at the component and press and hold the [DEVICE] key for 3 seconds until the Device LED blinks off and turns back on. Continue holding the [DEVICE] key and press the numberkeys, one at a time, starting with 1, then2, 3...0.
Page 5
this for other Device until you have stored all the desired power commands into the [ALL OFF] button. STEP4 Press the [CH5] button to save the power commands you stored. The [STB] button will blink twice to confirm the Device have been saved. Programming for On Demand Button Programming for On Demand...
Page 6
Memory Lock System. Memory Lock System. This remote control is designed to retain programmed memory for 10 years — even after batteries are removed from the remote control. For additional information about your remote control, go to www.universalremote.com...
Need help?
Do you have a question about the UR2-211 and is the answer not in the manual?
Questions and answers