Universal Remote Control Customizer URC-300 Owner's Manual page 11

When the display shows "MAIN", you are back in
10
normal operating mode. Now it's time to test all
the buttons. If some buttons don't work, try
repeating steps 1-9, to see if you can improve the
match to your component.
For Example: My Sony TV powered off with TV
code number 139. However the number buttons
didn't work when I tested them. So, I repeated
steps one to ten, using other code numbers and
eventually discovered that when code number
185 is set, all the buttons work perfectly.
Repeat steps one through nine for each of your
11
devices. In most systems, you can finish basic
setup in just a few minutes and put all your old
remote controls away.
If you are still missing commands to control any
of your devices, use the Learning Method on the
next page.
U R C - 3 0 0
9