Section 4: Erasing Macropower Commands - Universal Remote Control Universl Remote Owner's Manual

SECTION 4: Erasing MacroPower Commands

STEP 1: For erasing MacroPower commands on the POWER ON
or SYSTEM OFF button, press and hold either the POWER ON or
SYSTEM OFF button and the MUTE button simultaneously for 3
seconds until the component LED light turns on.
IMPORTANT: If you don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and you will need
to start over.
STEP 2: Press the CHANNEL UP button to erase and exit the
Erase mode. The component LED light will blink three times to
confirm the erasure.
31