Advertisement
Cisco Aironet Directional Hyperlocation Antenna (AIR-ANT25-LOC-02=)
Step 7
Mount the antenna–mount flange assembly on to the flange mount on the pole. For guidance, see the
short-link mount bracket assembly in
Tighten the hose clamps until the antenna is fully secure on the mast. Ensure that the antenna cannot
Step 8
rotate about the mast.
Connect the antenna cables to the access point.
Step 9
Mounting using Mount Arm-Flanges Bracket Assembly
You can mount the antenna on a wall or a pole, vertically, with both azimuth and elevation adjustment. For this you will
need to use the full bracket assembly which includes the mount arm and the mount flanges. See
Figure 16
Mount Arm-Flanges Bracket Assembly
The following table lists the materials needed for this installation:
Materials Needed
Mount Arm-Flanges Bracket assembly as shown in
Figure
1/2 in. (13-mm) wrench or socket
(For pole mounting only)
Worm-gear type hose clamp (50-135mm). 2 nos.
D r a f t L a b e l — C i s c o C o n f i d e n t i a l
13.
Figure
11.
Factory-Shipped?
Yes
No
Yes
23
Figure
16.
Advertisement
