Advertisement
Cisco Aironet Directional Hyperlocation Antenna (AIR-ANT25-LOC-02=)
Figure 15
Short-Link Mount Assembly
The following table lists the materials needed for this installation:
Materials Needed
Short-Link mount bracket assembly parts, as
shown in
1/2 in. (13-mm) wrench or socket
(For pole mounting only)
Worm-gear type hose clamp (50-135mm). 2 nos.
Slotted screwdriver
(Used for tightening the screws on the hose
clamps.)
(For wall mounting only)
Four mounting screws and wall anchors
(Used for mounting the antenna and bracket
assembly on a wall. These fasteners should be
capable of maintaining a minimum pullout force of
150 pounds (68 kg) to support the weight of the
antenna and bracket, plus the potential wind
loading on the antenna.)
(Optional, and for wall mounting only)
Roxtec Multidiameter™ cable sealing system
(http://www.roxtec.com/)
Drill, drill bits, and a pencil.
Mounting the Antenna on a Wall
To mount the antenna on a wall using the short-link mount bracket assembly, follow these steps:
Step 1
Familiarize yourself with:
D r a f t L a b e l — C i s c o C o n f i d e n t i a l
Figure
10.
Factory-Shipped?
Yes
No
Yes
No.
No
No
No
21
Advertisement
