Appliance Settings; Sensors; Unbalanced Load Detection System - Siemens WH34A2X0HK Instruction Manual And Installation Instructions

Appliance settings

en
Q
Appliance settings
Y ou can change the following settings:
A p p l i a n c e s e t t i n g s
The volume of the end signal.
■
The volume of the button signal.
■
Switching the drum care information
■
signal on/off.
You will need to activate the setting
mode in order to change these settings.
1/2/3/4... positions on the
programme selector
Activate setting mode:
Set the programme selector to
1.
position 1. The appliance is switched
on.
Touch and hold the 0 Spin Speed
2.
button and, at the same time, turn
the programme selector clockwise to
position 2. Release the 0 Spin
Speed button.
The setting mode is activated and the
preset setting appears in the display
panel.
36
Changing the volume and drum care
information
Use the B Finish in button to change
the following settings at the
corresponding programme selector
positions:
2: The volume of the end signal.
■
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
4: Switching the drum care
■
information signal on/off.
on
Ž
Πoff
Exiting setting mode
You can now end the process and set
the programme selector to the Û (Off)
position. The settings are saved.
H

Sensors

U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.