Safety Instructions; Installation Surface; Installation On A Base Or A Wooden Joist Floor; Installing The Appliance In A Kitchenette - Siemens WH34A2X0HK Instruction Manual And Installation Instructions

Safety instructions

:
Warning
Risk of injury!
The appliance is very heavy.
■
Be careful when lifting/transporting
the appliance.
When the appliance is lifted by its
■
protruding parts (e.g. the appliance
door), the components may break
off and cause injuries.
Do not lift the appliance by
protruding parts.
If the hose and mains cables are not
■
routed properly, there is a risk of
tripping and injury.
Lay hoses and cables in such a way
that there is no risk of tripping.
Caution!
Damage to the appliance
Frozen hoses may rip/burst.
Do not install the appliance in areas
exposed to frost or outdoors.
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Notes
In addition to the safety information
■
listed here, the local water and
electricity supplier may have special
requirements.
If in doubt, have the appliance
■
connected by a specialist.

Installation surface

The appliance must be stable
Note:
aligned so that it does not move
around.
The installation surface must be firm
■
and level.
Soft floors/floor coverings are not
■
suitable.
Positioning and connecting
Installation on a base or a
wooden joist floor
Caution!
Damage to the appliance
The appliance may "wander" and tip/
topple from the base when spinning.
The feet of the appliance must be
secured with holding brackets.
Order no. WMZ 2200, WX 975600,
CZ 110600, Z 7080X0.
On wooden joist floors, install the
Note:
appliance:
In a corner, if possible,
■
On a water-resistant wooden board
■
(min. 30 mm thick) which is screwed
tightly to the floor.
Installing the appliance in a
kitchenette
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Do not remove the appliance covering
plate.
Notes
Recess width of 60 cm required.
■
Only install the appliance
■
underneath a continuous worktop
that is securely connected to
adjacent cabinets.

Removing the transport locks

Caution!
Damage to the appliance
The appliance is secured for
■
transportation using transport locks.
If the transport locks are not
removed, the appliance may
become damaged when it is
operated.
Before using the appliance for the
first time, make sure that you
completely remove all four transport
locks. Keep the locks in a safe
place.
en
13