Water Inlet - Siemens WH34A2X0HK Instruction Manual And Installation Instructions

Positioning and connecting
en

Water inlet

:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Do not immerse the Aqua-Stop safety
valve* in water (it contains an electric
valve).
* Depending on the model
Observe the following when connecting
the appliance:
Notes
Only operate the appliance using
■
cold mains water.
Do not connect the appliance to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
16
Connection
Connect the water supply hose to
1.
the water tap (¾" = 26.4 mm) and to
the appliance:
– Model: Standard
– Model: Aqua­Secure
– Model: Aqua-Stop
Connect also an external water
Tip:
filter (depending on the model)
between water supply hose and tap.
The filter filters dirt particles out of the
water.
Water filter must be cleaned regularly
to remove contaminants. This will
prevent blockages. See also ~
separate installation and cleaning
instruction for water filter.