Agilent Technologies 990 Micro GC Safety Manual page 8

Important Safety Warnings
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
8 Agilent 990 Micro GC and 990 Mobile Micro GC Chromatograph Safety Manual
The supplied power cord must be inserted into a power outlet with a
protective ground connection. When using an extension cord, make sure that
the cord is also properly grounded.
Do not change any external or internal grounding connections, as this could
endanger you or damage the instrument.
The instrument is properly grounded when shipped. You do not need to make
any changes to the electrical connections or to the instrument chassis to
ensure safe operation.
When working with this instrument, follow the regulations for Good
Laboratory Practices (GLP). Take care to wear safety glasses and
appropriate clothing.
Do not place containers with flammable liquids on this instrument. Spilling
liquid over hot parts may cause fire.
This instrument may use flammable or explosive gases, such as hydrogen gas
under pressure. Before operating the instrument be sure to be familiar with and
to follow accurately the operation procedures prescribed for those gases.
Never try to repair or replace any component that is not described in this
manual without the assistance of an Agilent service engineer. Unauthorized
repairs or modifications will result in rejection of warranty claims.
Always disconnect the AC power cord before attempting any type of
maintenance.
Use proper tools when working on the instrument to prevent danger to you or
damage to the instrument.
Do not attempt to replace any battery or fuse in this instrument other than as
specified in the manual.
Damage can result if the instrument is stored under unfavorable conditions for
prolonged periods. (For example, damage will occur if stored while subject to
heat, water, or other conditions exceeding the allowable operating conditions).
This unit has been designed and tested in accordance with recognized safety
standards and designed for use indoors.
If the instrument is used in a manner not specified by the manufacturer, the
protection provided by the instrument may be impaired.
Substituting parts or performing any unauthorized modification to the
instrument may result in a safety hazard.
Changes or modifications not expressly approved by the responsible party
for compliance could void the user's authority to operate the equipment.