Channel Positioning; Spike Fixing - Monitor Audio MONITOR REFERENCE Series Owner's Manual

2 Channel Positioning

For use in a 2 channel system, the listening position and the loudspeakers should form an equilateral triangle. The speakers
should be positioned approximately 6 - 10 feet (1.8 - 3m) apart. They ideally need to be between 8 - 18 inches (20 - 45cm) away
from the rear and 3 feet (1m) from the side walls.
Experimentation is strongly advised when initially setting up your speakers, as environments and personal preference differ
with each installation. If there is not enough bass, for example, then try moving your speakers closer to a wall. The opposite, if
there is too much bass. Also see the information on page 5 refering to Port Bungs. If you are loosing stereo imaging, try 'toeing'
them in slightly. The sound should appear to originate from the centre point between the speakers, not the actual speakers
themselves.

Spike Fixing

The Monitor Reference Series floor standing loudspeakers, come with spikes. These enhance the acoustic performance of the
loudspeaker and should be used where possible. The spikes can be found in the packaging of the MR4 and MR6 only.
BEWARE. The spikes are very sharp, and could cause injury if care is not taken when handling them. Please ensure
there are no hidden wires under the carpet, or trailing mains leads that could be damaged by the spikes.
1. Carefully place the cabinet on it's top or back to fit the spikes.
2. Screw the spikes into the threaded inserts on the bottom of the cabinets.
3. Carefully turn your speaker back over and check that it is evenly balanced. If uneven, you can adjust the height in the
appropriate (lowest) corner by unscrewing the spike slightly. This operation may need to be repeated a several times to
ensure your cabinet is completely level. When you are happy with the balance of the cabinet, tighten the locking nut on
each spike.
monitoraudio.com 3