Page 1
WORK SAFE! WORK SMART! IF YOU HAVE ANY QUESTIONS ABOUT THE PROPER USE OF THE EQUIPMENT, SEE YOUR SUPERVISOR, USER INSTRUCTIONS, OR CONTACT WERNER CO. FOR MORE INFORMATION. Werner Co. Fall Protection 724-588-2000 93 Werner Rd.
13. Only lanyards designed for tie-back are approved for tie-back directly onto the webbing. 14. Do not work on the far side of an opening, opposite the SRL anchor point. 15. Only Werner Co., or persons or entities authorized in writing by Werner Co., shall make repairs or alterations to the equipment.
Page 3
TRAINING: Do not use SRL’s without proper training from a “competent person” as defi ned by OSHA 29 CFR 1910.140(b) and 1926.32(f). REPAIRS: Only Werner Co., or persons or entities authorized in writing by Werner Co., may make repairs or alterations to the equipment.
B) at least two times the maximum arresting force for certifi ed anchorages; C) according to ANSI Z359.6, Specifi cations and Design Requirements for Active Fall Protection Systems. When more than one personal fall arrest system is attached to the anchorage, the strength in (A) or (B) must be multiplied by the number of personal fall arrest systems attached to the anchorage.
Page 5
WARNING! Striking objects horizontally due to the pendulum effect of a swing fall may cause serious injury or death. SWING FALL HAZARD WING ALLS To minimize the possibility of a swing fall, anchor as Anchorages directly above the work area as possible. Striking objects horizontally, due to the pendulum effect, may cause serious injury.
OPERATION EFORE WARNING! Before using a personal fall arrest system, employees must be trained in accordance with the requirements of OSHA 29 CFR 1910.30 and 1926.503 and/or applicable local, state, governmental and jurisdictional agencies, in the safe use of the system and its components. Personal fall arrest systems, including SRL ’s, must be inspected prior to each use for wear, damage, and other deterioration.
governing occupational safety may require the user to conduct more frequent or mandatory inspections. RITERIA WARNING! If inspection reveals any defect, inadequate maintenance, or unsafe condition, remove from service until a “competent” person, as defi ned by OSHA 29 CFR 1910.140(b) and 1926.32(f), can determine the need for authorized repair or disposal.
Page 9
AINTENANCE WARNING! Only Werner Co., or persons or entities authorized in writing by Werner Co., shall make repairs or alterations to the equipment. SRL’s requiring maintenance must be tagged “unusable” and removed from service. Do not use any SRL that requires maintenance. Cleaning and maintenance may be performed by the user.
Page 10
Qualified Person to take User Manual prior to use and follow twice the foreseeable load. To minimize accordingly. If missing, contact Werner swing fall, anchor as directly above work Co. for a replacement. Inspect product area as possible. Check for unobstructed prior to each use, then at least monthly by a clearance beneath.
Page 11
Read all warnings and instructions in User Manual prior to use a Qualified Person to take twice the foreseeable load. and follow accordingly. If missing, contact Werner Co. for a To minimize swing fall, anchor as replacement. Inspect product prior to each...
Need help?
Do you have a question about the AUTOCOIL 2 and is the answer not in the manual?
Questions and answers