Page 1
WORK SAFE! WORK SMART! IF YOU HAVE ANY QUESTIONS ABOUT THE PROPER USE OF THE EQUIPMENT, SEE YOUR SUPERVISOR, USER INSTRUCTIONS, OR CONTACT WERNER CO. FOR MORE INFORMATION. Werner Co. Fall Protection 724-588-2000 93 Werner Rd.
SRL. 15. Do not work on the far side of an opening, opposite the SRL anchor point. 16. Only Werner Co., or persons or entities authorized in writing by Werner Co., shall make repairs or alterations to the equipment.
Page 3
TRAINING: Do not use SRL’s without proper training from a “competent” person as defi ned by OSHA 29 CFR 1910.140(b) and 1926.32(f). REPAIRS: Only Werner Co., or persons or entities authorized in writing by Werner Co., may make repairs or alterations to the equipment.
ANSI Z359.2 states that anchorages selected for fall arrest systems must have a strength capable of sustaining static loads, applied in all permitted directions by the system: A) no less than 5,000 pounds (22.2 kN) for non-certifi ed anchorages; or B) at least two times the maximum arresting force for certifi ed anchorages;...
Page 5
WARNING! Striking objects horizontally due to the pendulum effect of a swing fall may cause serious injury or death. SWING FALL HAZARD WING ALLS To minimize the possibility of a swing fall, anchor as Anchorages directly above the work area as possible. Striking objects horizontally, due to the pendulum effect, may cause serious injury.
Page 7
Check the operation by pulling smoothly on the lifeline, then pulling sharply on the lifeline to engage the locking mechanism. SRL’s must be inspected prior to each use. See INSPECTION. ONNECTION WARNING! Never attach an additional energy absorbing lanyard, self retracting lifeline, or similar component to lengthen the lifeline.
AINTENANCE WARNING! Only Werner Co., or persons or entities authorized in writing by Werner Co., shall make repairs or alterations to the equipment. SRL’s requiring maintenance must be tagged “unusable” and removed from service. Do not use any SRL that requires maintenance.
Page 9
WARNING: Read all warnings and instructions in User Manual prior to use and follow accordingly. If missing, contact Werner Co. for a replacement. Inspect product prior to each use, then at least monthly by a competent person who is not a user. Before use withdraw and retract some webbing and tug sharply to ensure that the pawls engage properly and the unit retracts normally.
Need help?
Do you have a question about the Bantam 6 and is the answer not in the manual?
Questions and answers