Schiller BOB-CAT PROCAT 5000 Operator's Manual page 16

CONTROLS
FUEL VALVE (U) -
provided. The fuel tank selector valve has three posi-
tions:
Off: The tank selector is off when the lever points
down. The selector should be off whenever the
machine is transported or stands unused for any
length of time. Shutting off the fuel supply avoids the
possibility of flooding should any dirt get under the
carburetor float needle. Leaving the tank selector in
either tank position can allow severe flooding, which
may ruin the engine by diluting the oil.
Right Tank: Fuel flows from the right tank when the
selector is turned 1/4 turn toward the right, when fac-
ing the valve.
Left Tank: Fuel flows from the left tank when the
selector is turned 1/4 turn toward the left, when fac-
ing the valve.
FUEL GAUGE LH (FL) -
left-side tank.
12V OUTLET (O) -
accommodate 12V accessories such as cell phone
chargers.
SWITCH BLANK (SW) -
switch used with the optional grass collector or towed
aerator installed.
Located on left side control panel.
ARMREST REMOVED FOR CLARITY
SW
14
A fuel tank selector valve is
Indicates fuel level in
A 12V outlet is provided to
Shown with the dump
FL
O
U
DECK LIFT &
TRANSPORT LATCH LEVER (D & T)
back on the deck lift lever D to raise the deck . When
the deck is completely raised, the transport latch T
engages to hold the deck in the transport position. To
lower the deck pull back on the lift lever D, then raise
the latch T. Lower the deck lift lever until it contacts
height of cut pin A.
HEIGHT OF CUT PIN (A)
and allows easy return from transport to desired
height of cut. Raise the deck to transport using the
foot pedal and deck lift lever D. Position pin A in
the hole corresponding to the desired height of cut.
Lower the latch lever until it rests on pin A.
TRACTION LEVERS (L)
tion levers controls the drive wheel located on the
same side. They control the forward and reverse
movement of the machine, provide steering and also
provide dynamic braking.
The operator must be in the seat and the parking
brake must be OFF or the engine will kill if the trac-
tion drive is engaged. To engage traction drive, move
the traction levers toward the center of the machine
until they are out of neutral lock position.
Lift and Traction Levers
(operator's right side)
L
- Pull
- Sets height of cut
- Each of the two trac-
D
T
A