Schiller BOB-CAT PROCAT 5000 Operator's Manual page 13

USED ON 61" MODELS
- Spring length for when installing
new belts only.
- Do NOT readjust after use.
USED ON 52" MODELS
- Spring length for when installing
new belts only.
- DO NOT readjust after use.
USED ON 48" MODELS
- Spring length for when installing
new belts only.
- Do NOT readjust after use.
OPERATOR'S MANUAL IS LOCATED
UNDER THE FOOT PLATE.
N
N
R
4165616
4175231
WARNING
- Rotating parts.
- Do not operate with cover
removed.
4176925
20A FUSE
20A FUSE
85 87
STARTER
RELAY
30C 86
4177592
4167202
F
F
N
N
R
4165615
2000577
85 87A 87
DELAY
RELAY
30C
86
85 87
85 87
TRACTION CLUTCH
RELAY RELAY
30C 86 30C 86
4176226
4176399
LABELS
TO CHECK OR ADD
FUEL
-Do it outdoors.
-Stop engine. Allow to
cool.
-Do not smoke.
-Clean up spilled fuel.
-Do not overfill.
-Fill to one inch below
bottom of filler neck.
2000570
WARNING
AVOID INJURY OR DEATH
FROM ROLL OVER:
Keep roll bar in the raised
position and use seat belt.
THERE IS NO ROLL OVER
PROTECTION WHEN THE
ROLL BAR IS LOWERED.
Lower the roll bar only
when necessary and
NEVER remove it.
Do NOT use seat belt when
the roll bar is down.
Raise the roll bar as soon
as clearance permits.
Read and follow all safety
instructions and warnings
in the operator's manual.
CAUTION
ROLL OVER PROTECTION
STRUCTURE
To maintain opeartor
protection and roll bar
certification:
Replace a damaged roll
bar. DO NOT attempt to
repair or modify.
Any alteration of the roll
bar must be approved by
the manufacturer.
DO NOT exceed the
machine weight rating of
the roll bar.
11