Adjusting The Airflow Direction - Sanyo SAP-K71GJA Technical & Service Manual

1. Horizontal
2. Vertical
A. Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
NOTE
OI-378-19EG

Adjusting the Airflow Direction

The horizontal airflow can be adjusted by moving the vertical vanes with your
hands to the left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation may
begin to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control
unit. Do not move the flap with your hands. Confirm that the remote control
unit has been turned on. Use the FLAP button to set either the sweep function
or one of the six airflow direction settings.
B. Setting the Airflow Manually
• The flap automatically closes when the unit is off.
• Use the FLAP button on the remote control to adjust the position of the
flap. If you move the flap by hand, the flap position according to the
remote control and the actual flap position may no longer match. If this
should happen, shut off the unit, wait for the flap to close, and then turn
on the unit again; the flap position will now be normal again.
• Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
Referring to the above illustration, use the
FLAP button to set the airflow direction
within the range used during the cooling or
dehumidifying operation.
: http://splitoff.ru/tehn-doc.html
19