How to Install Batteries
NOTE
How to Use the Remote
Control Unit
Remote Control Unit
Installation Position
DO NOT
10
Using the Remote Control Unit
•
The batteries last about six months, depending on how much you
use the remote control unit. Replace the batteries when the remote
control unit's display fails to light, or when the remote control
cannot be used to change the air conditioner's settings.
•
Use two fresh leak-proof type-AAA alkaline batteries.
•
In replacing batteries, follow the instructions as mentioned in the
sub-section ''How to Install Batteries''.
•
If you do not use the remote control unit more than 1 month, take
out the batteries.
When using the remote control unit, always point the unit's transmitter head
directly at the air conditioner's receiver.
Air conditioner
(Indoor unit)
Remote control
unit
The remote control unit may be operated either from a non-fixed position or
from a wall-mounted position. To ensure that the air conditioner operates
correctly, DO NOT install the remote control unit in the following places:
•
In direct sunlight
•
Behind a curtain or other places where it is covered
•
More than 8 m away from the air conditioner
•
In the path of the air conditioner's airstream
•
Where it may become extremely hot or cold
•
Where it may be subject to electrical or magnetic noise
•
Where there is an obstacle between the remote control unit and air
conditioner (since a check signal is sent from the remote control unit
every 3 minutes)
1.
Slide the cover in the direction
indicated by the arrow and
remove it.
2.
Install two AAA alkaline
batteries. Make sure the
batteries point in the direction
marked in the battery
compartment.
3.
Use a thin object such as the
tip of a pen to press the ACL
button.
ACL button
Receiver
(Transmitter head)
: http://splitoff.ru/tehn-doc.html
OI-378-10EG