Back View - Unitech PA500 User Manual

Back View

No. Component
10.
Speaker
11. Battery release latch
12. Reset button
13. Main battery
14. Universal connector
15. Earphone jack
16. Right scanner trigger key
17.
Infrared (IR) port
18. Stylus
4
Copyright 2007 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Description
When speaker phone is active,
sounds are emitted here.
Slide toward the right side of the device and hold firmly,
then detach the battery from its bay.
Press the end of the stylus into the button to reset your
device.
Removable and rechargeable 3.7 V, 2200 mAh battery
pack.
Connects your device to a USB charging/communication cable. This
Connects your device to a USB charging cable, which in
USB cable connects to the computer's USB port and accepts the 5V AC
turn connects to the computer's USB port and through
adapter to provide power to the PA500.
the AC adapter to an electrical outlet. This allows you to
The unit can simultaneously recharge and perform an ActiveSync
recharge your device and perform an ActiveSync
operation. You can also use it to connect peripheral hardware, such as
a docking station, to your device.
operation.
This port can also support USB and RS232 hosting for devices such as
You can also use it to connect a peripheral hardware,
a USB or RS232 scanner, keyboard, or USB memory key.
such as a docking station, to your device.
Lift the rubber cover from the earphone jack and connect
an audio line-out device (earphone or headphone).
Press to activate the barcode laser scanner.
Uses infrared technology to transmit and receive data
from other IR-enabled devices.
To use the stylus, remove it from its holder and hold it the
same way as you hold a pen or pencil.