Bayer HealthCare MEDRAD Stellant Operation And Installation Manual page 10

®
MEDRAD Stellant ISI 700 Module Operation and Installation Manual
The following icons may appear on the injector screen for those who have the
Display and Control Unit (DCU):
The injector is configured for ISI and it is communicating to the ISI module. The scanner
signals are in a state that will allow arming the injector.
The user is not able to arm the injector. The injector is configured for ISI, and it is
communicating to the ISI 700 module. The injector and ISI module are functional, but the
scanner signals are in a state that will NOT allow arming the injector.
Communication is lost between the injector and the ISI module.
OR
The ISI module is in need of repair. Refer to the ISI System Messages section of this manual.
The following icons may appear on the injector screen for those who have a
Certegra Workstation:
The injector is configured for ISI and it is communicating to the ISI module. The scanner
signals are in a state that will allow arming the injector.
The user is not able to arm the injector. The injector is configured for ISI, and it is
communicating to the ISI 700 module. The injector and ISI module are functional, but the
scanner signals are in a state that will not allow arming the injector.
Communication is lost between the injector and the ISI module.
OR
The ISI module is in need of repair. Refer to the ISI System Messages section of this manual.
Scanner ready.
When icon is gray, Injector is not Armed and not ready for injection. When icon is highlighted in
yellow and flashing, Injector is armed and ready of the injection.
IPX1 Code that specifies the degree of
protection provided by the enclosure
against vertically falling water drops (IEC
60529)
Identifies the Protective Earth Ground
point. (IEC TR 60878, 5019)
See accompanying documentation. This
symbol indicates the user shall refer to the
instructions-for-use to ensure safe
operation. (ISO 7010, M002)
Consult instructions for use. (ISO 15223-1,
5.4.3)
4