Startup; Configuring Your Phone; Configuring Via Web User Interface - Yealink SIP-T23P Quick Start Manual
Hide thumbs
Also See for SIP-T23P:
- Quick start manual ,
- User manual (180 pages) ,
- Quick installation manual (4 pages)
Table of Contents
Advertisement
STARTUP
After the IP phone is connected to the network and supplied
with power, it automatically begins the initialization process.
After startup, the phone is ready for use. You can configure the
phone via web user interface or phone user interface.
CONFIGURING YOUR PHONE
CONFIGURING VIA WEB USER INTERFACE
Accessing the web user interface:
1. Press the
OK
key when the phone is idle to obtain the IP address of the phone.
2. Open a web browser on your computer, enter the IP address into the address bar (e.g.,
"http://192.168.0.10" or "192.168.0.10"), and then press the Enter.
3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm.
Network Settings:
Click on
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP
Address: If the phone cannot contact a DHCP server for any reason, you need to configure the
IP address, subnet mask, gateway address, primary DNS address and secondary DNS
address for the phone manually.
Note:
•
The IP phone also supports IPv6, but IPv6 is disabled by default.
•
The wrong network settings may result in inaccessibility of the phone and may have an impact on
the network performance. Contact your system administrator for more information.
Account Settings:
Click on
Parameters of the account:
Register Status:
It shows the register status of the current account.
Line Active:
You can select Enabled/Disabled to enable/disable the account.
Label:
It is shown on the LCD screen to identify the account.
Display Name:
It is shown as Caller ID when placing a call.
Register Name:
It is an authenticated ID for authentication provided by ITSP (required).
User Name:
It is provided by ITSP for registration (required).
Password:
It is provided by ITSP for registration (required).
Server Host:
It is provided by ITSP for registration (required).
Register status icons on the LCD screen:
Registered
Network->Basic->IPv4 Config
Account->Register->Account X
Registering
Yealink IP Phone – SIP-T23P & SIP-T23G
(X=1,2,3)
Register Failed
5
Quick Start Guide
Advertisement
Table of Contents
