Replacing The Fuses - ELNA 6200 Service Manual

TO REMOVE:
1. REMOVE THE FRONT COVERS (SEE PAGE 8).
2. REMOVE THE PRINTED CIRCUIT BOARD "A". REMOVE THE FOUR SETSCREWS AND
REMOVE THE COVER FROM THE PRINTED CIRCUIT BOARD "A".
3. REMOVE THE FUSE (PRY UP THE FUSE WITH A SCREWDRIVER).
NOTE
1. REPLACE THE PRINTED CIRCUIT BOARD "A" IF YOU NOTICE ANY BROWNING,
DISCOLORATION, OR OTHER ABNORMALITIES.
2. ONLY INSTALL FUSES WITH THE CORRECT RATING.
IF THE FUSE IS LOOSE, BEND THE FUSE CLIPS INWARD TO SECURE THE FUSE.
FUSE NO.
F2, F3
F1
SETSCREWS (4)

REPLACING THE FUSES

REPLACING THE FUSES REPLACING THE FUSES REPLACING THE FUSES REPLACING THE FUSES
MANUFACTURE
WALTER
ELECTRONIC
WALTER
ELECTRONIC
PRINTED CIRCUIT BOARD "A" (UNIT)
F３
AC250V 2.5A
PRINTED
CIRCUIT
BOARD "A"
COVER
DESCRIPTION
TSD-2.5A-250V
5.2 x 20 mm 2.5A PART # 000144605
TSC-3.15A-250V
5.2 x 20 mm 3.15A PART # 000182904
F1
AC250V 3.15A
F2
AC250V 2.5A
FUSE HOLDER
29
FUSE