Bayliner DX2000 Owner's Manual page 45

Chapter 10: Electrical System
· NEVER install non-ignition protected switches or other arcing devices in the
fuel compartment.
· NEVER substitute automotive parts for marine parts. Marine electrical,
ignition, and fuel system parts were designed and manufactured to comply
with rules and laws that minimize the risks of fire and explosion.
· NEVER change the electrical systems or relevant drawings.
· Allow ONLY trained personnel to install batteries and/or do electrical system
work.
· NEVER work on the electrical system installation while system is energized.
· NEVER leave the craft unattended with the electrical system energized,
except automatic bilge pump, file protection and alarm circuits.
· NEVER install or replace electrical appliances or devices with components
which exceed the rated current amperage of the circuit.
· NEVER alter or modify the rated current amperage of overcorrect protective
devices.
Fuel vapors can explode! BEFORE turning on electrical devices or working on
the electrical system:
Check the bilge areas for fuel vapors or leaking fuel. If you see leaking fuel or
smell fuel vapors:
· Do NOT start the engine, do NOT turn On any electrical devices, put out
ALL cigarettes, cigars, and other sources of flame or ignition.
· Get everyone off your boat.
· Get trained help to find and fix the problem.
When the engine is running, NEVER disconnect the battery cables. Doing so
could cause damage to your boat's engine and/or electrical system.
Electrical connections are prone to corrosion. To reduce corrosion-caused electrical
problems:
· Keep ALL electrical connections clean.
· Apply a spray-on protectant that is designed to protect connections from
corrosion.
®
39
l
!
EXTREME FIRE, SHOCK and EXPLOSION HAZARD!
!
FIRE and EXPLOSION HAZARD!
!
SHOCK and ELECTRICAL SYSTEM DAMAGE HAZARD!
Chapter 10: Electrical System