Bayliner DX2000 Owner's Manual page 41

Windlass (If Equipped)
· Read and follow the manufacturer`s manual before using the anchor windlass for the first time.
· The windlass can be controlled from a switches located at the helm.
· Make sure that windlass circuit breaker and windlass switch at the helm is turned on before using the anchor
windlass.
· To raise the anchor, use engine power to move you r boat to directly above the anchor.
· Dislodge the anchor from the bottom by pulling it straight up with the windlass.
· Before getting underway, make sure that anchor is secured and the windlass switch is turned off.
An unsecured anchor could accidentally release while your boat is
moving, damaging your boat and causing serious injury or death. After
retrieving secure the anchor with an anchor safety strap and chain
locker. To avoid accidental operation switch off the windlass circuit
Do NOT rely on the windlass alone to hold your boat at anchor! After
setting the anchor, tie the rode off to a cleat or equivalent strong point.
Do NOT pull your boat to the anchor using windlass, to continue running
the windlass if it has stalled or is overload.
®
35
l
!
!
breaker.
Chapter 7: Deck Equipment