Table of Contents
Advertisement
This change remains in effect until scan is turned off.
Scan then reverts to the preprogrammed (original)
setting.
Making a Dynamic Priority Change via the
preprogrammed Dynamic Priority button:
a) When the radio locks onto the channel
designated as the new Priority-Two channel,
press the preprogrammed Dynamic Priority
button.
The radio continues scanning the remaining
channels in the list.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or
noise (termed a "nuisance" channel), you can
temporarily remove the unwanted channel from the
scan list.
This capability does not apply to priority channels or
the designated transmit channel.
Note:
Deleting a nuisance channel is only possible
through the preprogrammed Nuisance
Channel Delete button.
48
English
When the radio is locked onto the channel to be
deleted, press the preprogrammed Nuisance
Delete button.
The radio continues scanning the remaining channels
in the list.
Restoring a Nuisance Channel
To restore the deleted nuisance channel, perform
one of the following actions:
•
Stop and restart a scan.
•
Mode change to another channel and back to
the original channel.
•
Turn off the radio and then turn it on again.
Nuisance mode delete can be disabled by the
system administrator.
Call Alert Paging
This feature allows your radio to work like a pager.
The radio which you missed its call can send a Call
Alert page to your radio. The sender also able to
know that your radio is active.
Advertisement
Table of Contents
