Programming The Acps-610; 1: Installing The Configuration Software - Honeywell Notifier ACPS-610/E Manual

Configuration and Programming
Figure 3.1 below gives two examples of setting the base address with both rotary and slider switch
settings.
SETTING

3.2 Programming the ACPS-610

Use PK-PPS to program the ACPS-610's global functions and individual outputs. With PK-PPS,
you can configure and download the ACPS-610 database and update firmware. You can modify a
power supply's configuration online, or offline, on a database that can be download at a later date.
PK-PPS is bundled as a separate program on the VeriFire Tools installation CD
(P/N VERIFIRE-TCD). Updates are available for download from www.magni-fire.com.
3.2.1 Installing the Configuration Software
Minimum Requirements
• Windows XP Professional with SP2, or Windows 2000 with SP4.
• PC or Laptop with USB 2.0 port.
Installation
1.
2.
3.
4.
5.
6.
28
SW2 SW3
ROTARY SLIDER SWITCH
SWITCH POSITION
Figure 3.1 SLC Address Selection
Log in. The user must have Administrative priveleges.
Insert the CD into the PC's CD drive.
Double click on the file PPS.exe on the CD.
Follow the instructions of the PPS installation wizard to completion.
Connect the ACPS-610 to the PC via the USB cable. (See Section 3.2.2.) Wait for the
operating system to detect the new hardware.
Follow the set of steps in Table 3.2 below that are specific to your operating system.
SLC
SLC ADDRESSES
BASE
SELECTED
ADDRESS with maximum
fourteen ACPS-610
005
005-018
120
120-133
ACPS-610/E Manual — P/N 53018:A1 07/31/2007
Programming the ACPS-610