Connecting Your Scanner To A Personal Computer; Volume/Squelch With Pc Control; Wired Cloning - Uniden UBCD996T Owner's Manual

2. While pressing [2] [9] , , and [HOLD] at the same time, turn on power.
At that point anything you have programmed is gone.
You are given a last opportunity to keep the factory programmed data when you see
the question:
Restore Preprogram List? Yes="E"/"No= "."
If you do not say Yes, the scanner is totally empty.

Connecting Your Scanner to a Personal Computer

You can connect your scanner, by means of the
supplied cable, to a personal computer to
download data from the computer to the memory of
the scanner. Before you proceed, you must first set
the scanner's communications speed as described
in the previous section. In addition you will need a
copy of Uniden Advanced Scanner Director
software. You can download the software from
www.uniden.com.au in the Customer Service
Downloads link.
Important: Start with a high baud rate setting. If, during transfer, you get an error
message, reduce the setting and start again until you get reliable, complete transfer
of data.

Volume/Squelch with PC Control

If you use a PC to control the scanner, and you change the scanner's volume or
squelch setting using the PC, the scanner ignores the front-panel control's current
setting. However, if you later change the volume or squelch setting using the front-
panel control, the scanner uses the control's setting (i.e. the scanner pays attention
to the last method used).

Wired Cloning

Using the scanner in a cloning setup lets you transfer programmed data directly from
a source or master UBCD996T to a target or slave UBCD996T. Wired cloning
between other models to the UBCD996T is not possible.
[MENU] or (select one as the master
Wired Clone Master Slave
and one as the slave)
60