Table of Contents
Advertisement
(8) Adjusting the sensor
A
Align
❺
❷
❸
B
❾
❾
Turn power ❺ ON while keeping
1)
tion setting screen is displayed.
2)
Press
The screen is changed over to
the sewing mode screen.
3)
Depress the back part of pedal.
The origin is retrieved and the
presser foot is held at its upper
position. Depress the back part
of pedal again to lift the presser
foot.
4)
Keep
❶
The function setting screen is dis-
played.
5)
While the function setting No.
❹
flashes ON and OFF, press
ting No. A to "123".
❸ to flash set value B ON and
6)
Press
OFF.
Press
by the number of pulses corresponding to
the number of times you have pressed
❷ by pressing
Adjust so that the marker line on the cam
is aligned with the edge of plate ❾ .
*
If you have failed to follow the correct step of
procedure in the middle of operation, do not
❹ . Instead, press
press
exit from the function setting screen.
With the aforementioned measure, it is pos-
sible to exit from the function setting screen
without saving the data you have changed.
– 8 –
❶ held pressed. The func-
❶ .
❶ held pressed.
❷ to set the function set-
❷ . Then the cam rotates
❹ .
❶ to
Advertisement
Table of Contents
