Clamping The Workpiece; Repositioning The Drill Table; Angled Drilling - Westfalia 28 31 19 Instruction Manual

Laser drill machine 250 w

Table of Contents

Clamping the Workpiece

1. The drill table and the base are provided

with mounting slots for the use of clamping

tools. Use these mounting slots for fix the

workpiece with an appropriated tool, e. g. a

vice.

2. Always

fix

appropriate tool on the table.

Never hold the workpiece by hand! There

is risk of injury!

The drill table is attached with the table holder

on the column and tightened with the clamping

bolt (P). When loosening the clamping bolt you

can adjust the height of the drill table.

If you have to drill very long workpieces that have to be fixed directly on the base,

you can easily move the drill table aside.

When you have to drill very small workpieces, make sure to adjust the correct

position of the drill table. Observe the correct distance between workpiece and

drill tip.

For performing angled drilling or when

drilling workpieces with inclined surfaces,

you can tilt the drill table.

1. Loosen the drill table clamp screw

(part no. 4) under the drill table, tilt the

table into the desired position and

retighten the clamp screw.

2. Always fix the workpiece on the table.

Never hold the workpiece with you

hand while drilling.

the

workpiece

Start-up

with

Table of Contents