Setting The Pulse/Tone Switch - Uniden XCA650 Instruction Manual

If the talk/batt low LED begins to flash, the phone is programmed to limit its
functions to save power. The table below describes what to do to return your
phone to normal operation.
DURING A CALL
A
Only the button operates.
The Handset beeps and the talk/batt
low LED flashes once every 3 seconds.
Complete your call as quickly as
possible.
Return the Handset to the Base Unit for
charging.
Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge.

Setting the Pulse/Tone Switch

Be sure the PULSE/TONE switch is in the TONE position.
Note: Most phone systems are Tone dialing. Check with your local phone company
if you are not sure whether your system is Tone or Pulse dialing.
IN STANDBY MODE
None of the buttons will operate.
The Handset talk/batt low LED flashes
once every 3 seconds.
You will not be able to make a call.
Return the Handset to the Base Unit for
charging.
26