Chain Dialing; Erasing A Stored Number From Memory; Changing The Digital Security Code - Uniden XS210 Owner's Manual

XS210.Qx 10/6/03 5:27 PM
If you press
and a phone number is not
stored in the one-touch
Rocket Dial location, the
phone will beep rapidly and
will not dial.
If the handset battery pack
is completely discharged or
the battery pack is removed,
the digital security code will
be lost. If this happens, a
new security code is set
automatically next time the
battery pack is charged.
Page 9
One-touch Rocket Dial
Your phone is equipped with "One-touch Rocket
Dial" for instant dialing. It is used to dial the phone
number stored in the one-touch Rocket Dial location
(See "Storing a Phone Number in Memory" on page
7).
To instantly dial the phone number stored in the one-touch Rocket Dial
location, simply press
phone will automatically dial).

CHAIN DIALING

The memory locations on the handset are not limited to phone numbers.
You can also store a group of numbers (up to 20 digits) that you need to
enter once your call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Once you have called your bank,
and are prompted to enter the account number, simply press
location number ( ) where the special number has
been stored.
Store your special number in memory as you would store a phone number
(Refer to "Storing a Phone Number in Memory" on page 7).

ERASING A STORED NUMBER FROM MEMORY

1) Remove the handset from the base unit.
2) Press twice.
3) Press or the memory location (
that the stored number is erased from memory.

CHANGING THE DIGITAL SECURITY CODE

The digital security code is an identification code used to connect the
handset and the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the
same security code, you can change the code.
1) Remove the handset from the base unit. Press and hold
the base.
2) The handset begins emitting a paging sound. While holding
, place the handset in the base unit. The paging sound
stops. Leave the handset in the base for more than 3 seconds. A new
random security code is set.
. (There is no need to press
). A tone indicates
8
. The
and the
on