Using The Attachments - Kenwood FDM30 Instructions Manual

using the attachments

Refer to recommended speed chart for each attachment.
knife blade
p
Follow the instructions under "to use your food processor".
dough tool
q
Use for yeasted dough mixes.
Follow the instructions under "to use your food processor".
dual whisk
r
Use for light mixtures only eg egg whites, cream, evaporated
milk and for whisking eggs and sugar for fatless sponges.
Heavier mixtures such as fat and flour will damage it.
using the whisk
1 Fit the bowl onto the power unit, add the detachable drive shaft.
2 Push each beater securely into the drive head.
3 Fit the whisk by carefully turning until it drops over the drive
shaft.
4 Add the ingredients.
5 Fit the lid - ensuring the end of the shaft locates into the centre
of the lid.
6 Switch on.
discs -
s c
To use the discs.
Follow the instructions under "to use your food processor".
to use the cutting discs
1 Fit the bowl onto the power unit, add the detachable drive shaft.
2 Holding by the centre grip , place the disc onto the drive shaft
with the appropriate side uppermost.
3 Fit the lid.
4 Put the food in the feed tube.
5 Switch on and push down evenly with the pusher - never put
your fingers in the feed tube.
134699 Iss 1 FDM30 Eng_Arabic.B5.indd 8
citrus juicer
c
(if supplied)
Use the citrus juicer to squeeze the juice from citrus fruits (e.g.
oranges, lemons, limes and grapefruits).
cone
sieve
to use the citrus juicer
1 Fit the drive shaft and bowl onto the power unit.
2 Fit the sieve into the bowl - ensuring the sieve handle is locked
into position directly over the bowl handle.
3 Place the cone over the drive shaft turning until it drops all the
way down.
4 Cut the fruit in half. Then switch on and press the fruit onto the
cone.
The citrus juicer will not operate if the sieve is not
l
locked correctly.
centrifugal juicer
cm
Use the centrifugal juicer for making juice from firm fruit and
vegetables.
pusher
centrifugal lid
pulp remover
filter drum
bowl
juicing spout
to use the centrifugal juicer
1 Place the juicer bowl with the spout
align the on the bowl with the
clockwise  until it locks
2 Place the pulp remover
tabs locate with the slots in the bottom of the drum 
3 Fit the filter drum N
.
4 Place the attachment lid
locks . Your juicer will not operate if the bowl or lid
are not fitted correctly into the interlock h.
5 Place a suitable glass or jug under the juice outlet.
6 Cut the food to fit the feed tube.
7 Switch on and push down evenly with the pusher - never put
your fingers in the feed tube. Process fully before adding
more.
After adding the last piece, let the juicer run for a further 30
l
seconds to extract all the juice from the filter drum.
important
I f the juicer starts to vibrate, switch off and empty the pulp from
l
the drum. (The juicer vibrates if the pulp becomes unevenly
distributed).
Maximum capacity that can be processed at one time is 800g of
l
fruit or vegetables.
Some very hard foods may make your juicer slow down or stop.
l
If this happens switch off and unblock the filter.
Switch off and clear the pulp collector regularly during use.
l
8
(if supplied)
onto the power unit,
on the power unit and turn
.
into the filter drum - ensuring the
.
onto the bowl and turn until it
21/03/2017 16:05